Four Cylinder 1650cc Custom Injector Set (isc-1650h-4) Height (Measured from O-ring to O-ring):38mm(34mm) Comes with new hardware

Comes with new hardware

Tilton’s Honda Clutch & Flywheel assemblies are designed to be a direct replacement for the stock assemblies

The CAN H-Bridge device can be used to supply protected low side (GND) or high side (VBat) supply independently to each of 4 outputs for bidirectional DC motor control

SPL Parts Rear Endlinks (RE) feature massive 1/2" FK Rod Ends to provide the highest load capacity for use with stock or stiffer aftermarket sway bars

(Patent No

Four Cylinder 1650cc Custom Injector Set (isc-1650h-4) Height (Measured from O-ring to O-ring):38mm(34mm) Comes with new hardware1650cc Custom Injector Set for a 4 Cylinder Engine Call us at (561) 427 0082 and we walk you through the setup you need. Custom injector sets include solder in pigtails. This injector set is precisely matched using Fuel Injector Clinic's proprietary Data Match Technology. Each injector is individually serial numbered and the results are provided on the Data Match Sheet providing the most complete flow matching and latency value information available